2/9/2024 0 Comments Cvs over ssh bastionImportant: This must be modified for FX60. Important: In the pop-up window 'Programming Properties' enable "Erase Before Programming" button. Select the first xcf08p device and right click on it and choose 'Program.'.At the end the configuration is as follows: A prompt advances in the chain as each device is configured for a firmware that is displayed in the bottom of the device. Continue to choose slice.bit and hit 'cancel' as many times as necessary (8 * 2) until all daisy-chained devices are configured.Click 'Cancel' when prompted again for the *.bit file in pop-up for the xc4vfx20 FPGA.The cursor advances to the xc4vfx20 fpga firmware setup. When this is done, the first xcf08p is now set to be programmed with the ' slice.bit' firmware.Choose slice.mcs for the xcf08p flash eeprom in the 'Assign New Configuration File' pop-up.xc4vfx20 is the FPGA that can be programmed with the slice.bit file. The JTAG devices discovered by the scan are displayed as daisy-chained chips in the right panel: xcf08p is the flash that can be programmed with the slice.mcs file. Right Click and choose 'Initialize chain'.Double click on 'BoundaryScan' from left.Click on 'OK' when the following pops-up:Ĭlick on 'Cancel' when the following pops-up:.Start the iMPACT software to bring up the GUI impact.Go to directory containing the download-able firmware cd release/rcehw/slice/syn.(As the local file system mirrors the bastion host, npa64.csh is present) source npa64.csh Connect to the cds lab machine that is hooked upto the JTAG device ssh atca02.Flash the firmware using JTAG device and iMPACT SW.This is approximately in the middle of the board. Connect the other end to the JTAG connector that is closer to the FX20 slice chip sets in the RCE board.Connect USB end of the JTAG connector to the USB port of a cds machine (Ex: atca02 which is alias for rdcds202).Set up the JTAG Connectivity to connect to FX20.slice.bit for firmware that is placed in xc4vfx20 FPGA ram. Either of them can be downloaded: slice.mcs for firmware that is flashed into xcf08p flash eeprom. Check to ensure there are no build errors grep error slice.bld Two firmware files are generated in the current directory. Build process can take more than an hour.Kick off the build accepting all default values for command arguments perl.Go to the directory containing the perl build script cd release/rcehw/slice/syn.Otherwise, just 'cvs update rcehw') cvs co rcehw Check out rcehw from CVS (if not done already.Otherwise, just 'cvs update release') cvs co release Check out release from CVS (if not done already.Connect to a lab bastion-host machine (rdusr201 or rdusr202) ssh rdusr201.Step by step instructions for building and flashing FX20
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |